Flush mount motion detector, 3 wires, 160°

This motion sensor with a minimum load of just 1W turns on your LED lighting too. Create more comfort and safety in your living room, hallway or basement. The 3-pin connector makes the installation very simple. Due to its design it is suitable for AC circuit of two motion sensors and can also be installed in cavity wall sockets. The light sensitivity and the switching time can be adjusted according to your needs.

  - detection angle: about 160°
- detection range: max. 9m
- minimum load: 1W
- maximum load: 1200W
- operating at 230V/50Hz
- installation dimension: 52x50x35mm (w-h-d)
- installation height: about 1000-1800mm
- dimension (panel): about 80x80mm
- suitable for hollow wall box: Ø68mm
- switching time: about 10sec – 7min
- sensitivity: <5lux (adjustable)
- on/off/PIR
- elegant plastic housing in white
- easy installation due to 3-pole connector (neutral conductor required)
- switching time and light sensitivity adjustable
- installation height: 100-180cm
- suitable for LED’s
- LED display
- only suitable for indoor installation
- all details according to manufacturer