Flush-mounted motion detector 2-wire 160° | LED suitable

This motion sensor with a minimum load of just 1W turns on your LED lighting too. Create more comfort and safety in your living room, hallway or basement. The 2 pole connector makes the installation very simple. Due to its design it is suitable for AC circuit of two motion sensors and can also be installed in cavity wall sockets. The light sensitivity and the switching time can be adjusted according to your needs.

technical details:
- detection angle: approx. 160°
- detection range: max. 9m
- minimum load: 1W
- maximum load resistive loads: 500W (eg incandescent lamps)
- maximum load inductive loads: 200W (e.g. LEDs)
- operation at 230V / 50Hz
- installation dimensions 49x49x30mm (WxHxD)
- installation height: 100-180cm
- dimensions (decorative panel): approx 80x80mm
- suitable for flush-mounted boxes Ø60mm
- suitable for cavity wall boxes Ø68mm
- switching time: about 10 seconds to 7 minutes
- sensitivity: 3-2.000 lux (adjustable)
- on / off switch / PIR
- elegant plastic housing in white, silver or anthracite
- easy installation due to 2-pole connection
- switching time and light sensitivity adjustable
- LED status display
- only suitable for indoor installation
- all details according to manufacturer

Your order includes:
- 1x flush-mounted motion detector 2-wire, 160°, white or
- 1x flush-mounted motion detector 2-wire, 160°, silver or
- 1x flush-mounted motion detector 2Draht, 160°, anthracite