We send free shipping within Germany!
Motion detector 12-24V | 8m PIR | IP20
With the help of this small motion detector, the light in your living area switches on as soon as you enter the room.
item number: 60000424
- detection angle: approx. 60°
- input: 12V-24V DC
- output: 12V-24V DC
- connection load: max. 72W
- output voltage:
- 6A at 12V
- 3A at 24V
- own consumption:
- StandBy 0.1W
- operating 0.35W
- detection range: approx. 8m
- adjustable duty cycle: 1-10min
- dimensions: approx. 76x45x34mm (WxHxD)
- protection class: IP20
- all details according to manufacturer
- input: 12V-24V DC
- output: 12V-24V DC
- connection load: max. 72W
- output voltage:
- 6A at 12V
- 3A at 24V
- own consumption:
- StandBy 0.1W
- operating 0.35W
- detection range: approx. 8m
- adjustable duty cycle: 1-10min
- dimensions: approx. 76x45x34mm (WxHxD)
- protection class: IP20
- all details according to manufacturer
Technical info
indoor area
assembly
ceiling / wall
standard
IP20
Caution:
The maximum connection load of 72 watts must not be exceeded. The detector may only be operated with 12V-24V DC (DC). The mounting location must be chosen in such a way that there are no thermal influences such as direct sunlight, heating, ventilation etc.. Avoid mounting where the sensor points to moving curtains, plants, etc. The movement detector must not be covered, as this could lead to overheating of the electronics inside. The installation should always be connected by qualified specialists. The valid accident prevention regulations have to be observed. For avoiding an electric shock please cut off the electricity supply of the device before you start your work.
The maximum connection load of 72 watts must not be exceeded. The detector may only be operated with 12V-24V DC (DC). The mounting location must be chosen in such a way that there are no thermal influences such as direct sunlight, heating, ventilation etc.. Avoid mounting where the sensor points to moving curtains, plants, etc. The movement detector must not be covered, as this could lead to overheating of the electronics inside. The installation should always be connected by qualified specialists. The valid accident prevention regulations have to be observed. For avoiding an electric shock please cut off the electricity supply of the device before you start your work.
